Posted by S Andersen [172.70.54.45] on Wednesday, August 17, 2022 at 07:56:38 :
In Reply to: Wheel bearings? posted by Jim Lee [108.162.246.146] on Monday, August 15, 2022 at 16:22:08 :
I did this procedure on my WC-57 per TM9-808 which Vaughn described below. I didnt even turn any wheels, just followed the book. Only issue I had was to make sure the hub was ALL the way on before doing the procedure. "Adjust Wheel Bearings. Turn the inner adjusting nut up tight and then back it off about 1/6 of a turn. Install the adjusting nut lock, making sure that the dowel pin in the inner adjusting nut enters a hole in the lock. It may be necessary to turn the lock over or even turn the inner adjusting nut slightly to permit the dowel pin to enter
one of the holes in the lock. With the lock over the dowel pin, install the outer adjusting nut and tighten it securely."
Follow Ups: