Posted by Willy-N [108.162.245.67] on Sunday, September 02, 2018 at 15:20:18 :
In Reply to: Can't find the problem yet! TH400 posted by Willy-N [108.162.245.145] on Sunday, September 02, 2018 at 02:11:46 :
Well I check every part starting from the Tail Shaft forward and nothing was wrong till I got to the Front 1st and 2nd Clutch Pack Opened it up and found a couple over heated looking Disks! Not all of them so I needed to look further and did. Found a scored section on the ring that holds it in the Transmission. But there is no reason for the score to be there unless it was the reason it was re/built the last time. Something must have got in there once and grabbed it in one spot. No disk goes between this it just holds the clutch pack in. Moved on down the line found no problems so the valve body was next as I just took it off and sat it aside doing the tear down. This time I looked at it and the Front Clutch Pack Servo was on a angle not sure how I missed that right away? It was jammed up and pushing the pin going to the front clutch pack all the time. This pin is bent I rolled it on a Precision Granit Block and you could feel it. So this $10.00 part cause the problem. Still need to replace a few disks so I will just install the whole kit even stuff not wore out. All I can figure is the bump going into the ditch messed with the shifter on the side and things went south after that? I need to buy this part it is not in the kit. The smaller photo album shows the damaged parts. The manual said this could be a problem so it was right but Valve body is a big part with stuff inside and outside. I checked all the plungers they work just fine inside it.
Follow Ups: