Posted by Willy-N [162.158.106.87] on Sunday, September 02, 2018 at 23:09:01 :
In Reply to: Re: Can't find the problem yet! TH400 posted by TGP (IL) [162.158.75.37] on Sunday, September 02, 2018 at 22:44:02 :
Got the center bolt in no problem made sure the thrust bearing was seated right before the bolt when in with a flashlight. I put 4 bolts in the tail shaft and balance it on them to do it. Word but had to be careful. Read on line some snag a clutch disk and bend the little teeth down. I will do a complete tear down which is not hard again just to be sure nothing is out of place or damaged. It is not hard if I can get the clutch Pack assembly that just slid in and held in place by the pump back out! It seems jammed for some reason and very tight no movement at all on the outside housing. I removed the clutch disks to see if I could get ahold better. Nothing to hold on too and don't want to turn it upside down and bang the case on the table. Trying to figure how to put a puller in there to push and pull at the same time. Tomorrow with a fresh mind I an going to see if I can build up a tight fitting handle to pull on it with. Don't want to mess up the Clutch pack housing. They have no threaded holes to put a bolt in.
Follow Ups: