Re: be carefull on milling the head

Posted by mikey stone Idaho,USA [71.39.211.41] on Thursday, July 28, 2011 at 09:03:26 :

In Reply to: 2 barrel carb on a 230. posted by Tom in Indiana [32.170.31.217] on Thursday, July 28, 2011 at 02:22:08 :

might (probably) has been milled before
you might raise the compression too much

Follow Ups:

• Re: be carefull on milling the head - kaegi 11:48:05 07/28/2011
  • Kaegi, modern spring pressure too? - Chris Case 21:59:46 07/28/2011
  • Show your math? I'll show you mine... - ChrisCase 14:59:07 07/28/2011
    • Re: Show your math? I'll show you mine... - Kaegi 15:45:01 07/28/2011
    • Re: Show your math? I'll show you mine... - M Fanoni 15:42:17 07/28/2011
      • I converted 85cc, from memory.... - ChrisCase 16:10:25 07/28/2011
        • Re: I converted 85cc, from memory.... - clueless 14:49:47 07/29/2011
        • Re: I converted 85cc, from memory.... - M Fanoni 16:18:15 07/28/2011
  • Re: be carefull on milling the head - M Fanoni 12:15:48 07/28/2011
• Any specs on OE head thickness? - ChrisCase 09:26:39 07/28/2011
  • A couple more, 1.920, 1.930 - ChrisCase 11:38:53 07/28/2011
    • Re: A couple more, 1.920, 1.930 - dave royal 17:34:38 07/28/2011
      • The squish is the whole area above the piston. - ChrisCase 21:46:53 07/28/2011
        • Addendum: transfer slot... - Chris Case 21:54:23 07/28/2011

Post a Followup