Re: Flame Thrower coil

Posted by Jerry in Idaho [108.162.246.146] on Friday, September 16, 2022 at 12:29:00 :

In Reply to: Re: Flame Thrower coil posted by Vaughn [172.71.158.49] on Friday, September 16, 2022 at 08:41:26 :

I have an MSD conversion in my '66 F350 with a 428 engine. I will have to say this: It works great until it stops working. This has only happened twice in about 20 years, but when it does, there's no going anywhere under my own power. Of course the original stuff can fail but it's a little easier to carry an extra set of points or a coil. The replacement parts on most electronics require analyzers to find the problem, or just start replacing, which gets expensive.
Personally, for a flathead 6 cylinder I think the original parts are best.

Follow Ups:

• Re: Flame Thrower coil - Vaughn 15:02:35 09/16/2022
  • Re: Flame Thrower coil - Steve in FH 03:30:05 09/17/2022
    • American Made - Vaughn 12:18:26 09/17/2022
      • Re: American Made - Steve in FH 15:52:05 09/17/2022
        • Re: American Made - Vaughn 18:23:45 09/17/2022
      • Re: American Made - Crane Cams - Vaughn 12:24:01 09/17/2022
    • Re: Flame Thrower coil - Jerry in Idaho 11:44:19 09/17/2022
      • Re: Flame Thrower coil - Steve in FH 15:53:56 09/17/2022
        • Re: Flame Thrower coil - Jerry in Idaho 18:41:55 09/17/2022
          • Re: Flame Thrower coil - Vaughn 20:58:29 09/17/2022
            • Re: Flame Thrower coil - Steve in FH 02:01:06 09/18/2022

Post a Followup