Posted by Dean in CA [162.158.246.43] on Sunday, April 19, 2020 at 16:55:22 :
In Reply to: Re: Braden Winches posted by Jerry in Idaho [108.162.245.17] on Sunday, April 19, 2020 at 15:43:29 :
The winch was canted on the PW to give PTO
drive line clearance at the cross member.
The U in MU, MU2, MU3, etc refers to the worm
gear ( input shaft) being set low in the frame,
under slung of the mounting points. The MU3
sets flat on the frame, input parallel to ground
not canted down like the PW.
Follow Ups: