Fittings

[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]

Posted by Milo in Pa [71.116.18.235] on Thursday, December 10, 2015 at 10:38:45 :

Im looking for some 90 degree fittings for master cylinder so I can put the rear side pto shaft in. The sizes show 9/16 18 for one port and 1/2 20 for the other port. I would need inverted flair on one male end for the master cylinder and female on the other end to put in the original master cyl fittings into. Still doing some searching.

Master cylender specs

Follow Ups:

Re: Fittings - Brent 21:56:07 12/10/2015

Re: Fittings - Milo in Pa 06:33:55 12/11/2015

Re: Fittings or Tight line bend - Milo in Pa 18:30:03 12/10/2015

Re: Fittings or Tight line bend - daveyKinPa 19:26:08 12/10/2015
- Re: Fittings or Tight line bend - Milo in Pa 21:28:01 12/10/2015
  - Re: Fittings or Tight line bend - Willy-N 02:30:32 12/11/2015

Re: Fittings - Paul(in NY) 15:20:07 12/10/2015

Re: Fittings - Milo in Pa 16:56:15 12/10/2015

Re: Fittings - Willy-N 13:10:48 12/10/2015

Re: Fittings - Milo in Pa 17:02:08 12/10/2015
- Re: Fittings - Willy-N 20:16:56 12/10/2015

Re: Fittings - Kevin in Ohio 11:10:58 12/10/2015

Re: Fittings - Milo in Pa 12:32:04 12/10/2015
- Re: Fittings - Kevin in Ohio 12:55:18 12/10/2015
  - Re: Fittings - Milo in Pa 17:12:56 12/10/2015

Post a Followup

Name:
E-Mail:
Subject:
Message:

Optional Link
URL:
Title:
Optional Image Link
URL:

This board is powered by the Mr. Fong Device from Cyberarmy.com