Posted by Milo in Pa [71.116.18.235] on Thursday, December 10, 2015 at 17:12:56 :
In Reply to: Re: Fittings posted by Kevin in Ohio [50.41.228.177] on Thursday, December 10, 2015 at 12:55:18 :
Thanks Kevin I tried no go with the inverted flair with the correct size and thread. I wanted to use the 90 degree elbow I measured and have about 2 1/2 inches between the flat on the master cylinder where the lines connect then over to the drive shaft. So if I can get some brake lines that are close bend is my only choice