Re: Slant 6 timing question

Posted by Sherman in Idaho [72.47.153.28] on Tuesday, April 29, 2014 at 15:29:52 :

In Reply to: Re: Slant 6 timing question posted by Kaegi [98.247.164.246] on Tuesday, April 29, 2014 at 15:09:29 :

Marks on sprockets are in exactly the same place, relative to keyways, as on the old sprockets. I checked to make sure before I removed the old ones. It's a Cloyes set, USA made. The damper pulley was made in Australia, so I was afraid they made it 180 degrees off, due to being on the bottom side of the Earth, but I compared it to the old one and it's the same.

Follow Ups:

• Re: Slant 6 timing question - Kaegi 15:58:08 04/29/2014
  • Re: Slant 6 timing question - Sherman in Idaho 16:13:48 04/29/2014
    • Re: Slant 6 timing question - Kaegi 16:19:59 04/29/2014
• Both straight up, or both point at each other = same. - Chriscase 15:40:39 04/29/2014
  • I agree, put it together like it should be. Hopefully - Dan (NH) 16:07:56 04/29/2014
    • Re: I agree, put it together like it should be. Hopefully - JohnD 19:14:59 04/29/2014
      • Re: I agree, put it together like it should be. Hopefully - Sherman in Idaho 22:02:15 04/29/2014

Post a Followup