Posted by wayneh [68.55.55.71] on Monday, March 25, 2013 at 19:05:56 :
In Reply to: transmission rebuild/inspection posted by justin in NJ [71.59.91.52] on Monday, March 25, 2013 at 11:47:59 :
Just one man's opinion.. but you took the time to take it out, take few more hours to rebuild it. It is not that hard, the manuals are available, and some are online and free. The army manual breaks it down into four sections, each one easy. I suspect your gears are fine, but at a minimum I would check and replace bearings and seals. And I would not spend one dime on a seal without the matching speedi seal to go with it. Some folks think it is character when their PW drips from the trans and transfer case, I find it annoying... Also, use thread sealant on EVERY bolt that penetrates the casting. Don't ask how I learned that.
Good luck
Wayne