or build a 3/4 spacer ?

[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]

Posted by casebro on Thursday, September 02, 2004 at 2:43PM :

In Reply to: Re: np435 np540 input shaft posted by Ken Dunnington on Thursday, September 02, 2004 at 1:03PM :

The spacer could be made from 1in aluminum, 4 bolt holes, and machined for the center bearing retainer, plus a locating collar on the front side. It depends on what kind of machinist is available locally. I'd go with a spacer, then next time you can use normal tranny parts.

Is your 540 an Overdrive? Find any extras?

Follow Ups:

Re: or build a 3/4 spacer ? - Ephraim 6:54PM 09/02/2004

Re: or build a 3/4 spacer ? - Ken Dunnington 3:21PM 09/02/2004

Post a Followup

Name:
E-Mail:
Subject:
Message:

Optional Link
URL:
Title:
Optional Image Link
URL:

This board is powered by the Mr. Fong Device from Cyberarmy.com