Search the Power Wagon Forum Archives Add T137 Archives Search to your Browser


Limit search to:
Sort by:
 Results for centered rear axle   381 to 400 of 546 results. Run time: 0.042 seconds | Search time: 0.009 seconds    
 Page:1 15 16 17 18 19 20 21 22 23 24 28 Previous 20 Next 20
381 Re: FRUSTRATION!! Someone (Norm, maybe?) please help!! -- rank: 265
... other than cost. In my situation I was driving the rear off of the hand brake output so as to have a centered rear axle, and that end yoke is hard to replace with a ... 440 Six Pack, and axles were Dana 70 front and rear with 38" Swampers. Frank Follow Ups: Post a Followup Name ...
Last Modified Date: 2006-12-11 00:00:01 CST
Document Size: 5620
Document Path: ../archives/wwwboard224/messages/2240430.html
382 anybody in vancouver -- rank: 265
... how it runs and how the plumbing goes to the rear axle etc.and ran the rear drive shaft to the rear pumpkin and if it is offset or centered or vice versa Follow Ups: Re: anybody in vancouver - clueless ...
Last Modified Date: 2013-10-05 05:20:23 CDT
Document Size: 5674
Document Path: ../archives/wwwboard429/messages/4290052.html
383 Custom Cummins 1954 Dodge M37 $40,000 [NY] -- rank: 265
... Turbo Aftercooled 2000 Dodge NV 4500, 5 speed overdrive transmission Centered rear axle housing 4.89 Differentials NP-205 T Case with disk ... hoses and 7 PSI pressure ARB Air Lockers front and rear with high output ARB compressor on board 2, 24 gallon ... s Magellan GPS Plug in tow truck jumper cables in rear bed Hella High Intensity lights on front winch mount High ...
Last Modified Date: 2016-07-07 16:28:22 CDT
Document Size: 13088
Document Path: ../archives/wwwboard504/messages/5040819.html
384 Update for Lubricant for "After Type" transmission -- rank: 265
... passes through as in a transmission in top gear. The rear drive shaft is connected to the yoke at the parking ... side) rather than the yoke on the right to the rear of the front drive shaft yoke, and I m using a WC centered rear axle. Doing this prevents a lot of power loss from the ...
Last Modified Date: 2024-01-21 06:41:24 CST
Document Size: 10645
Document Path: ../archives/wwwboard585/messages/5850520.html
385 1946 Dodge Power Wagon $3,500 [NH] -- rank: 265
... really rough, transmission has PTO, but it is facing the rear for the old dump pump that was on it. There ... in different conditions "one is rough, other best for parts Rear frame cross member Set of inner engine splash guards Transmission ... and instruction plates on it Two additional complete front ends Centered rear axle, not sure what it is from- think M37 Set of ...
Last Modified Date: 2020-07-14 06:12:00 CDT
Document Size: 9715
Document Path: ../archives/wwwboard562/messages/5620359.html
386 1946 Dodge Power Wagon $4,500 [NH] -- rank: 265
... really rough, transmission has PTO, but it is facing the rear for the old dump pump that was on it. There ... in different conditions "one is rough, other best for parts" Rear frame cross member Set of inner engine splash guards Transmission ... and instruction plates on it Two additional complete front ends Centered rear axle, not sure what it is from- think M37 Set of ...
Last Modified Date: 2021-12-18 05:49:14 CST
Document Size: 9675
Document Path: ../archives/wwwboard572/messages/5720714.html
387 Re: Anybody seen one of these -- rank: 265
... I put a Detroit 3-53 turbo in it. The rear axles are stock. I put a centered rear in the back. The bars connect to the shock mounts on the rear axle. Follow Ups: Re: Anybody seen one of these - Ippy 13 ...
Last Modified Date: 2020-05-30 07:54:10 CDT
Document Size: 8623
Document Path: ../archives/wwwboard561/messages/5610449.html
388 One big drawback to the Ranger.... -- rank: 239
... overdrive on the output of the transfer case to the rear axle for OD in 2WD. The OD must be able to ... Ranger.... - Charlie 1:42AM 01/07/2001 NP200 running a centered axle. - keith in Washington 6:49PM 01/08/2001 Re: NP ...
Last Modified Date: 2001-01-14 00:00:01 CST
Document Size: 6757
Document Path: ../archives/wwwboard35/messages/350967.html
389 Re: 1/2 ton or 3/4 ton or ...? -- rank: 239
... grille, and the radiator cap was under the hood. The rear (4.88:1) differental housing was centered, and all 1/2 tons had single-speed transfers. The ... cap through the shell, and an offset (5.83:1) rear differental. Early 3/4 tons had a single speed transfer ... 4X4. The 6X6 WC-62 or 63 was a 3-axle, 1-1/2 ton rig. It too looked like the ...
Last Modified Date: 1998-08-07 00:00:01 CDT
Document Size: 3502
Document Path: ../archives/wwwboard6/messages/138.html
390 Re: Locker in swivel??? -- rank: 239
... for someone building their own swivel (Paul), go to a centered rear diff axle, and run your drive through the swivel joint. I am ... keep it from rolling all the way over is the rear driveshaft! 1955 Swivel Frame "Fargo" Power Wagon Follow Ups: Jonas ...
Last Modified Date: 2002-11-10 00:00:01 CST
Document Size: 5823
Document Path: ../archives/wwwboard80/messages/800595.html
391 differential gasket -- rank: 239
... at 9:16PM : i'm rebuilding a 1/2 ton centered differential for my wdx. i'd like to use the ... gasket surface on the diff. side to the surfacewhere the rear cover is welded on)is 3 7/8. where as ... mic from the gasket surface to the center of the axle shafts then compare this to the differential? or should i ... i thought i'd ask before i start destroying a rear end thanks, jim. Follow Ups: Re: differential gasket - Vaughn 2 ...
Last Modified Date: 2002-11-19 00:00:01 CST
Document Size: 5861
Document Path: ../archives/wwwboard81/messages/810220.html
392 Re: Hub differences -- rank: 239
... Lowe on Tuesday, December 03, 2002 at 5:04PM : What axle did you get a hold of??? My 3/4 WC centered rear axle (Carryall) has the same setup as the PW. I have ...
Last Modified Date: 2002-12-07 00:00:01 CST
Document Size: 5428
Document Path: ../archives/wwwboard83/messages/830544.html
393 Re: Spotted a PW "FOR SALE" -- rank: 239
... the newer type axles. Also, the WW2 rigs have a centered rear axle, and the postwar vehicles have an offset rear diff. Hope this helps you figure it out. Charlie Follow ...
Last Modified Date: 1998-06-24 00:00:01 CDT
Document Size: 3607
Document Path: ../archives/wwwboard5/messages/536.html
394 Re: conversion stuff -- rank: 239
... two mid-50's Dodge 2WD trucks with full floating rear axles. As 4.89's are far more common on ... bolt right in a late war WC 3/4 ton centered rear axle housing, so I hope. I sold the WDX crewcab to ...
Last Modified Date: 1999-06-27 00:00:01 CDT
Document Size: 2761
Document Path: ../archives/wwwboard13/messages/172.html
395 Re: WC axles vs PW axles. -- rank: 239
... 13, 2001 at 12:26PM : Jonas: Check the WC front axle shock mounts to see if they have a stub shaft ... c (mounts to the brake drum) to drive the WC centered rear axle. Good luck! Follow Ups: Post a Followup Name: E-Mail ...
Last Modified Date: 2001-07-18 00:00:01 CDT
Document Size: 5289
Document Path: ../archives/wwwboard45/messages/450848.html
396 Re: WC and PW -- rank: 239
... to WC 3/4 and WDX. Front bumpers, winch, front axle, engine, transmission, PTO, steering gear. WC used long front frame ... 1.5 low). WC wheelbase 98"; WDX 126". WC had centered differential on rear axle; WDX's was off center to right side. WC had ...
Last Modified Date: 2001-05-29 00:00:01 CDT
Document Size: 5735
Document Path: ../archives/wwwboard42/messages/420509.html
397 Paul, nice work! -- rank: 239
... I also added the 2" blocks, but both front and rear, and not for the weight of the diesel, but for ... any bump steer from the 2" lift. I like the centered rear axle, look great. You are preparing to test your engine, and ...
Last Modified Date: 2005-08-31 00:00:01 CDT
Document Size: 6069
Document Path: ../archives/wwwboard183/messages/1830829.html
398 Yes, But.................... -- rank: 239
... December 17, 2003 at 0:09AM : In Reply to: Re: Centered t-case output with stock rear axle posted by Dan Lowe on Tuesday, December 16, 2003 at ... the right passanger seat would be and it drives a centered differential. Just the reverse of what were are taling about ...
Last Modified Date: 2003-12-26 00:00:01 CST
Document Size: 5725
Document Path: ../archives/wwwboard123/messages/1230236.html
399 This is how I do it... (Warning! it is completely unsafe!) -- rank: 239
... possible and weld it in place making sure everything is centered and true. You will also have to close up the ... truck shop, and put the whole mess together on the rear axle. Now this is the problem with that setup other than ... your front wheels will track in line with your inner rear wheels. Next option is to get a set (6) of ...
Last Modified Date: 2006-02-09 00:00:01 CST
Document Size: 6992
Document Path: ../archives/wwwboard197/messages/1970215.html
400 Dan H. in Southern Cal.... please email me. -- rank: 239
... 2006 at 10:11PM : In Reply to: Re: Looking for centered 3/4 ton WC rear axle... posted by Dan H on Sunday, February 26, 2006 at ... looking for command car body parts. specifically the front seats rear panle with map board/map case or any of these ...
Last Modified Date: 2006-03-02 00:00:01 CST
Document Size: 5357
Document Path: ../archives/wwwboard199/messages/1990847.html
 Page:1 15 16 17 18 19 20 21 22 23 24 28 Previous 20 Next 20