Search the Power Wagon Forum Archives Add T137 Archives Search to your Browser


Limit search to:
Sort by:
 Results for centered rear axle   341 to 360 of 548 results. Run time: 0.035 seconds | Search time: 0.006 seconds    
 Page:1 13 14 15 16 17 18 19 20 21 22 28 Previous 20 Next 20
341 Questions and ideas/help? -- rank: 306
... signals. I'm thinking about swapping out the front and rear axle assemblies for Dana 70/80's. Has anyone done it ... would it be to swap them out? Is there a rear that's really close to the same width of the stock rears? I could go to a centered rear axle and kill two birds with one stone that way. ...
Last Modified Date: 2011-07-23 05:18:56 CDT
Document Size: 11610
Document Path: ../archives/wwwboard364/messages/3641017.html
342 Better than the Pinto recall. -- rank: 306
... at 15:21:26 : The Pinto tank was at the rear bumper. In a rear ender it would get pushed forward and impale itself on the bolt on the rear axle. Big bolt for the rod that held the axle centered under the car. The recall consisted of sticking a ...
Last Modified Date: 2014-09-19 17:44:31 CDT
Document Size: 8063
Document Path: ../archives/wwwboard456/messages/4560295.html
343 Re: Tire size vs ring gear size on 1/2 ton WC -- rank: 306
... Depot upgrade to put the 9 5/8 in the rear of earlier 3/4 tons. Mine has a later rear axle as it has a welded cover on the back of the differential housing. I have another centered axle with a bolt on cover with the small diameter studs ... So that one is probably an early 8 3/4 axle. There are not any tags on it about using ...
Last Modified Date: 2018-09-04 17:59:46 CDT
Document Size: 7417
Document Path: ../archives/wwwboard542/messages/5420758.html
344 Re: synopsis -- rank: 306
... killer is usually an fully loaded truck with the short rear axle shaft. There is not enough length in the short axle to accommodate axle twist. A centered differential housing is much less likely to break an axle due to the short axle not being there and ...
Last Modified Date: 2019-03-26 17:54:35 CDT
Document Size: 8379
Document Path: ../archives/wwwboard549/messages/5490560.html
345 Re: Reasonable towing limit with FFPW? -- rank: 306
... thoughts. First I would be concerned about snapping the short axle shaft in the rear axle with that kind of weight. I have snapped them a ... much lower weights when starting up from a stop. A centered axle would do much better in the rear. Second that gasser may not have the power for ...
Last Modified Date: 2017-05-28 05:16:02 CDT
Document Size: 7735
Document Path: ../archives/wwwboard523/messages/5230486.html
346 Re: NV4500 - length/shaft to t-case solution -- rank: 288
... and just lengthen the front dr. shaft and shorten the rear. It would be nice to have both the front and rear dr. shafts the same length as to be interchangable. There ... as the PW T-case. Used on the front and rear output shafts at the T-case would seem to help ... a totally new OD tranny, new brakes idependent front and rear suspension axle w/centered diff., new 300hp hemi6 in-line or diesel,swivel ...
Last Modified Date: 2001-08-19 00:00:01 CDT
Document Size: 6306
Document Path: ../archives/wwwboard47/messages/471166.html
347 Re: Hook up to transfer -- rank: 288
... attempt (I think it's possible) to set up the rear output offset. 3) Use the same NP205 and use a rear axle with centered diff, but WW2 3/4 ton Dodge rear axles are, I believe, almost 3" wider than the M37 ... enough length to play with. Can you change (shorten) the rear tailhousing of the automatic to get another 5"? Or ...
Last Modified Date: 1998-04-21 00:00:01 CDT
Document Size: 3004
Document Path: ../archives/wwwboard3/messages/930.html
348 Re: I shouldn't have sold it! -- rank: 288
... bed slightly touched the back of the cab. The combination rear bumper/rear bed side support/taillight mount assembly was welded to the ... to clear the cab. In a perfect side view, the rear fenders are not centered on the rear wheel. This image shows that a little. Mechanically, the truck ... right front of the block. A piston mounted on the axle housing applied power to the tie rod. It was ...
Last Modified Date: 2005-02-06 00:00:01 CST
Document Size: 6888
Document Path: ../archives/wwwboard166/messages/1660481.html
349 Ring Gear Observations -- rank: 288
... my 1967 WM300 I pulled both of the differentials. The rear is getting a centered rear axle and the front needed a thourough inspection and a new ... the year of manufacture of this original ring gear. The rear diff shows some wear. The internal carrier housing has the ... 18:47:57 03/23/2010 Ditto on 'best to rear' - Chriscase 00:20:43 03/23/2010 Re: Ring ...
Last Modified Date: 2010-03-31 15:48:41 CDT
Document Size: 8467
Document Path: ../archives/wwwboard325/messages/3250239.html
350 Re: Yikes! -- rank: 288
... with ARB in the front, and a Miller in the centered rear. I have accepted axle breakage as part of the territory with these axles. I ... brake conversion, the ARB, and all new parts for an axle rebuild, I have quite a bit of $ tied up in that axle to just pull it at this point. I run the ... cheap Superwinch lockouts with the gaurds to cut down on axle breakage(the hubs break first and they are easier ...
Last Modified Date: 2009-12-08 15:53:04 CST
Document Size: 9837
Document Path: ../archives/wwwboard314/messages/3140187.html
351 Re: Dennan Overdrive -- rank: 288
... install the adapter shaft and preload the bearings in the rear bearing carrier. The bearings need to be set to something ... brake somewhere. You will also have to replace the offset rear axle with a centered one. Mounting the O/D to the offset output gets ... you have to make an adapter that will receive the rear output gear/shaft and bearings, mount the O/D, then ... the transfer case. The e-brake stays put, the offset rear stays put, but you need a more expensive adapter ...
Last Modified Date: 2015-11-17 16:55:54 CST
Document Size: 8923
Document Path: ../archives/wwwboard487/messages/4871033.html
352 Re: Driveshaft work -- rank: 288
... joint then the Detroit joints by .044". I have a centered rear axle from the 6x6 in my truck. The rear shaft I can use, but it has the small 5106 yoke on the t-case end, while the center rear output on my t-case is the larger 5380 size ... to the t-case, but they can't do the rear shaft without some way of mounting the small end ...
Last Modified Date: 2015-05-15 06:12:50 CDT
Document Size: 7873
Document Path: ../archives/wwwboard473/messages/4730307.html
353 Re: 70's -- rank: 288
... they are not as well built as the Chrysler unit. axle shafts like I said are stronger but that is it ... being a drop out. in 31 years I broke one axle in a 49 PW on the sort side. Most my other trucks had centered rear and never broke any. beat them hard offroad for many years. I would rather replace an axle than an integral diff any day. broken axle doesn't stop me from getting home. Follow Ups: ...
Last Modified Date: 2016-09-24 07:00:46 CDT
Document Size: 6841
Document Path: ../archives/wwwboard508/messages/5080577.html
354 Re: double U joint -- rank: 276
... have not yet discovered what does work with an offset rear axle driven from the inner/upper yoke on a transfer case ... other than a late WW II WC 3/4 ton centered rear axle). :( Follow Ups: Re: double U joint="double cardan joint" - DAvid ...
Last Modified Date: 2003-01-12 00:00:01 CST
Document Size: 6964
Document Path: ../archives/wwwboard88/messages/880603.html
355 80 mph WDX PW -- rank: 276
... PS, hanging pedals, 38.5" tires with 4.89s and centered rear differential. It was requested that I drive it down to ... was passing me)! Think I'll put a Dana 70 rear axle under mine when I do it, should be able to handle the higher speed than the original axle. Probably should get a radar detector and life insurance as ...
Last Modified Date: 2001-06-30 00:00:01 CDT
Document Size: 8026
Document Path: ../archives/wwwboard44/messages/440769.html
356 Tow truck story and Thanks to all that came to play -- rank: 276
... they all had sufficient clearance. The Jeep Cherokee got high centered. The exhaust and front and rear axles were resting on the ground. I backed up as close as I could till my rear axle was digging into the ground, and then we hooked the J hooks to the Jeep's axle and put some blocks of wood between the frame and ...
Last Modified Date: 2002-05-01 00:00:01 CDT
Document Size: 6555
Document Path: ../archives/wwwboard66/messages/660301.html
357 Yeah what he said and... -- rank: 276
... Note that on 1/2 ton WC's, the front axle has a wider track than the rear axle. That is so the front tire will be centered when the dualies are run. This is common on commercial ... larger tires. This made the vehicle track better since the rear tires ran in the same groove the front tire plowed ...
Last Modified Date: 1999-11-19 00:00:01 CST
Document Size: 5466
Document Path: ../archives/wwwboard18/messages/302.html
358 Re: wc 6x6 vs ffpw with 44x18.5x16.1 D. Higgins? -- rank: 276
... hear of someone who has one. As for the two rear axles being the same or different, they are the same ... a point. Because of the way they were powered (each rear axle having it's own drive shaft), one axle has an offset third member and the other is a centered diff. Both use the same third member though just like ...
Last Modified Date: 2002-10-05 00:00:01 CDT
Document Size: 6512
Document Path: ../archives/wwwboard77/messages/770949.html
359 A little story -- rank: 276
... and lock the Warns. We will need the front drive axle before we reach our destination. Getting back in the cab ... time keeping their vehicles from wandering. The load in the rear stabilizes my old truck on the soft ground. About a ... release one lever and pull another, engaging the front drive axle. The dog wants to scout so I let her canter ... Cadillac is mired in mud and gravel, having become high centered off the side of the road. I decide the best ... the other driver. I smile to myself; secretly knowing that rear locker is going to make this all too easy. The ...
Last Modified Date: 2003-01-12 00:00:01 CST
Document Size: 20046
Document Path: ../archives/wwwboard88/messages/880278.html
360 Re: NP205 History/amazing WC63 chassis/M37 body -- rank: 276
... 50 low range); the NP201 was next, it has a centered output and an odd 10 bolt PTO; next, the NP205 ... and Hercules diesel with 4.89s and one (the front rear axle) Lockrighted axle. What happens when both rear axles are lockered in a WC62/63? for that matter ...
Last Modified Date: 2000-12-06 00:00:01 CST
Document Size: 5642
Document Path: ../archives/wwwboard33/messages/330152.html
 Page:1 13 14 15 16 17 18 19 20 21 22 28 Previous 20 Next 20