Search the Power Wagon Forum Archives Add T137 Archives Search to your Browser


Limit search to:
Sort by:
 Results for centered rear axle   221 to 240 of 546 results. Run time: 0.035 seconds | Search time: 0.006 seconds    
 Page:1 7 8 9 10 11 12 13 14 15 16 28 Previous 20 Next 20
221 It is true Copey -- rank: 507
... killed three birds with one stone by using the offset rear differential: 1) The rear PTO shaft was able to be routed more directly in a straight line to the rear of the truck without a centered differential to contend with. True, it is not perfectly straight ... have been a quite a bit more complicated if a centered differential had been in place to work around. Remember, these ... has the same tubing size as the trucks front and rear drive shafts. Both rear PTO shafts have the same ...
Last Modified Date: 2009-04-05 17:09:50 CDT
Document Size: 10390
Document Path: ../archives/wwwboard295/messages/2950267.html
222 Re: Alloyed axle shafts for the Flat Fenders -- rank: 507
Re: Alloyed axle shafts for the Flat Fenders [Follow Ups] [Post Followup] [Dodge ... 11, 2011 at 23:06:57 : In Reply to: Alloyed axle shafts for the Flat Fenders posted by Dylan Robinson [67 ... with PW axles is the spline design and the offset rear diff. no flex on short side, long side can jump ... I think the best solution is to lose the offset rear axle and go with a centered one. I have been considering building a jig to ...
Last Modified Date: 2011-03-17 16:40:11 CDT
Document Size: 9103
Document Path: ../archives/wwwboard354/messages/3540660.html
223 Re: Could you use a Scout T19? -- rank: 507
... the Dana 18 is an offset transfer case. The Scout axle is centered. The original axle in the Willys is slightly off center if I remember ... Willys wagon drive train and frame it shows that the rear drive line is not parallel to the axis of the truck. It shows that the rear axle is more centered than the transfer case output. So ...
Last Modified Date: 2011-02-22 19:04:08 CST
Document Size: 11396
Document Path: ../archives/wwwboard352/messages/3520517.html
224 Stressed U joints -- rank: 501
... 2003 at 9:13PM : In Reply to: Anyone running a centered rear yoke on xfer case? posted by Jonas. on Wednesday, January ... 08, 2003 at 7:58PM : The angle of the single rear drive shaft going from the higher centered new rear yoke on the back of the transfer case to the lower offset PW rear axle yoke is excessive for the U joints and ...
Last Modified Date: 2003-01-12 00:00:01 CST
Document Size: 8682
Document Path: ../archives/wwwboard88/messages/880519.html
225 Re: Question on rear ends -- rank: 501
Re: Question on rear ends [Follow Ups] [Post Followup] [Dodge Power Wagon Forum] Posted ... 2011 at 11:25:43 : In Reply to: Question on rear ends posted by Bob in North GA [75.90.50 ... Saturday, October 22, 2011 at 11:05:12 : The FFPW rear end is the left over off-set style of the 6x6 front rear. This allowed greater flexibilty for the FFPW in use by allowing a rear PTO driven shaft. Some have experinced breakage in the long axle shaft of the off-set, and converted to the ...
Last Modified Date: 2011-10-27 16:55:06 CDT
Document Size: 9246
Document Path: ../archives/wwwboard371/messages/3710499.html
226 axle breakage and differrential centering -- rank: 492
axle breakage and differrential centering [Follow Ups] [Post Followup] [Dodge Power ... 2002 at 8:02AM : How much of a problem is rear axle shaft breakage in anything less than extreme offroad use? I am contemplating using a centered differential setup but before I do I thought I'd ... cons off of you guys. Has anyone here used a centered rear diff? Big difference/advantages? Would you do it again? ...
Last Modified Date: 2002-10-05 00:00:01 CDT
Document Size: 6093
Document Path: ../archives/wwwboard77/messages/770248.html
227 Boy, have I been wrong! -- rank: 489
... December 16, 2003 at 4:37PM : In Reply to: Re: Centered t-case output with stock rear axle posted by Fred Coldwell on Tuesday, December 16, 2003 at ... thought Dodge went to the trouble of changing from the centered rear differential to accomodate the rear PTO drive shaft. They were already producing a centered ...
Last Modified Date: 2003-12-26 00:00:01 CST
Document Size: 6330
Document Path: ../archives/wwwboard123/messages/1230196.html
228 Re: axle breakage and differrential centering -- rank: 486
Re: axle breakage and differrential centering [Follow Ups] [Post Followup] [Dodge Power ... Thursday, September 26, 2002 at 8:15AM : In Reply to: axle breakage and differrential centering posted by Ryan McNabb on Thursday ... are less likely to break an axel shaft in a centered rear diff. The sacrifice is ground clearance...an off-center diff, has a slight ground clearance edge over a centered unit. Having said all that, axel shaft breakage is likely ... or 4 thousand pounds of cargo on and your right rear wheel drops into a badger hole while you're ...
Last Modified Date: 2002-10-05 00:00:01 CDT
Document Size: 5909
Document Path: ../archives/wwwboard77/messages/770250.html
229 Re: Welding the axle housing on a FFPW. -- rank: 486
Re: Welding the axle housing on a FFPW. [Follow Ups] [Post Followup] [Dodge Power ... 2020 at 16:23:20 : In Reply to: Welding the axle housing on a FFPW. posted by Allen in NC [172 ... maybe now is a good time to upgrade to a centered rear housing? the 3/4 ton WCs have centered housing and NOS axles are about 75 a piece. the ... look around a bit for a housing. it eliminates broken rear axles. Injector Follow Ups: Re: Welding the axle housing ...
Last Modified Date: 2020-02-08 08:13:24 CST
Document Size: 8241
Document Path: ../archives/wwwboard558/messages/5580261.html
230 centered diff. again. -- rank: 481
centered diff. again. [Follow Ups] [Post Followup] [Dodge Power Wagon Forum ... question. i know what a late 3/4 ton wc rear axle housing looks like(welded rear cover) but how do you tell the external differences between ... the early 3/4 ton wc's? also will the axle shafts inter change between the 1/2 and 3/4 tons? thanks , jim. Follow Ups: Re: centered diff. again. - Dan Lowe 10:50PM 10/30/2002 ...
Last Modified Date: 2002-10-31 00:00:01 CST
Document Size: 5293
Document Path: ../archives/wwwboard79/messages/791042.html
231 Re: NP 200 can run straight through... -- rank: 481
... 63, used the NP-200 transfer case and drove the rear/rear tandem axle straight through off the back of the parking brake drum ... NP 200 transfer case can be used to drive a centered rear axle straight through from the transmission if that is one' ...
Last Modified Date: 2001-01-14 00:00:01 CST
Document Size: 6265
Document Path: ../archives/wwwboard35/messages/351000.html
232 Axle flip no help. -- rank: 481
Axle flip no help. [Follow Ups] [Post Followup] [Dodge Power Wagon ... to make a 6x6. But the real 6xt used a centered axle in front, an offset to the rear. The rear drive shaft had a pillow block on the shoulder of the front axle's differential bulge. The only point I can see ...
Last Modified Date: 2010-02-21 18:38:06 CST
Document Size: 9125
Document Path: ../archives/wwwboard321/messages/3210085.html
233 Re: Offset drive shaft on PW was used.. -- rank: 478
... 9:21PM : In Reply to: Re: Transfer case parking drum rear yoke... posted by Don Scott on Friday, February 16, 2001 ... the pumpkin (third member) hump in the middle of a centered rear axle under compression would have hit the tail shaft on the rear PTO under. Thunk! By using an offset rear axle, the engineers kept the pumpkin hump safely away ...
Last Modified Date: 2001-02-19 00:00:01 CST
Document Size: 5784
Document Path: ../archives/wwwboard37/messages/371263.html
234 Is the load-carrying capacity the same... -- rank: 472
... 2003 at 1:21PM : In Reply to: Anyone running a centered rear yoke on xfer case? posted by Jonas. on Wednesday, January 08, 2003 at 7:58PM : ...between a centered 3/4-ton WWII truck rear axle housing and the offset 1-ton FF Power Wagon axle housing? I don't know the answer to this, ...
Last Modified Date: 2003-01-12 00:00:01 CST
Document Size: 5946
Document Path: ../archives/wwwboard88/messages/880618.html
235 centered differential -- rank: 466
centered differential [Follow Ups] [Post Followup] [Dodge Power Wagon Forum] Posted ... am still looking for a 3/4 ton wc series rear axle with the centered differential and the large ring gear. swapping out my stock wdx rear. just need the housing and both shafts but would take ... n.y. area. thanks in advance,jim. Follow Ups: Re: centered differential- - - 1/2 -3/4 WC? year? - RDavis 11: ...
Last Modified Date: 2002-10-31 00:00:01 CST
Document Size: 6375
Document Path: ../archives/wwwboard79/messages/790500.html
236 Re: high strength axle shafts -- rank: 457
Re: high strength axle shafts [Follow Ups] [Post Followup] [Dodge Power Wagon Forum] Posted ... 21, 2004 at 1:36PM : In Reply to: high strength axle shafts posted by David N. Lundstrom on Monday, September 20 ... do not make axleshaft stock long enough for the longer rear axle in the PW. So people have not been able to get new axle shafts made for that side. If you go to a centered rear differential you will then have no problem having ...
Last Modified Date: 2004-09-23 00:00:01 CDT
Document Size: 5393
Document Path: ../archives/wwwboard151/messages/1510875.html
237 Axle Identification Help & Questions - helitool + arb lo -- rank: 457
Axle Identification Help & Questions - helitool + arb lo [Follow Ups] [Post Followup ... 27, 2007 at 22:59:39 : I picked up this axle assembly searching for parts for my '47 WDX restoration. I hope to use this axle with Ray's disc brake conversion and Shockley's arb ... it is a 1/2 ton or 3/4 ton axle? I understand that both were centered and used for the WC. (2) What are the differences between a 1/2 ton & 3/4 axle? (different bearings, hubs, axles, diffs, etc?) (3) I believe ...
Last Modified Date: 2007-12-01 00:00:01 CST
Document Size: 7958
Document Path: ../archives/wwwboard257/messages/2570397.html
238 Re: ? on rear steer -- rank: 457
Re: ? on rear steer [Follow Ups] [Post Followup] [Dodge Power Wagon Forum] Posted ... 23, 2007 at 14:21:39 : In Reply to: ? on rear steer posted by Pieter on Wednesday, May 23, 2007 at ... horseshoe shaped piece that attaches to each side of the axle housing, with a pivot point above the gear housing. Phyiscally moves the rear axle to turn, maybe? Follow Ups: Re: ? on rear steer - Pieter 16:37:58 05/23/2007 Hydraulic ...
Last Modified Date: 2007-05-26 00:00:01 CDT
Document Size: 6221
Document Path: ../archives/wwwboard240/messages/2400784.html
239 Re: more on axle -- rank: 457
Re: more on axle [Follow Ups] [Post Followup] [Dodge Power Wagon Forum] Posted by ... 2015 at 12:37:15 : In Reply to: more on axle posted by clueless [201.237.44.50] on Friday, January ... out in the mountains. I have only broke 1 short axle on a 49 I had. was on pavement. probably the ... on these trucks. not any more common than any comparable axle size. been on this forum since 04 and only seen one broken centered rear and I never broke any centered axles WW2 gen ...
Last Modified Date: 2015-01-25 07:05:39 CST
Document Size: 6456
Document Path: ../archives/wwwboard465/messages/4650522.html
240 axle housing price ? -- rank: 451
axle housing price ? [Follow Ups] [Post Followup] [Dodge Power Wagon Forum ... the going rate for a Dodge military 3/4 ton rear axle housing, no carrier,hubs,etc. ? Follow Ups: Re: Axle Housing Price ? - RDavis 6:26PM 07/08/2001 Late WC 3/4 ton centered rear axle... - Fred Coldwell 9:40AM 07/09/2001 Post ...
Last Modified Date: 2001-07-18 00:00:01 CDT
Document Size: 5301
Document Path: ../archives/wwwboard45/messages/450542.html
 Page:1 7 8 9 10 11 12 13 14 15 16 28 Previous 20 Next 20