Posted by Willy-N on Saturday, February 15, 2003 at 0:06AM :
In Reply to: Re: Finished Brakes today 4 in Pedal OK? posted by junkyard dog on Friday, February 14, 2003 at 7:36PM :
I had to make a plate to bolt on where the old one did and drop the new one down around a inch so I could get the cover off under the steering box. I used a 67-68 PW dual cylinder but it was a easy job to do. Removed the bottom bolt hole off the original mount and lowered the rod till it was straite and angled the mount so the cylinder was also level. Made it out of 1/4 inch plate and used a torch to cut the hole and a die grinder to smooth it out. I re/drilled the plate to the new mount and bolted it to the old mounting holes. I angled the plate just below the old bolt holes to line up everthing. I just need to weld a small peice on the side of the plate to remove any flex when braking hard because the 3rd mounting hole is not there. Complete setup was around 55.00 and a little time including the master cylinder. Mark H.