Posted by Unbelted on Saturday, December 21, 2002 at 0:45AM :
In Reply to: Re: This Board is Full of good Mechs and Adapters! posted by Willy-N on Friday, December 20, 2002 at 10:31PM :
Willy my software failed to work on the 3 point lift photos for the saws, plows, lift arm pump closeups and posthole digger will post it tormorrow when i get back, compressor bucking gas line tonite, the ford is the way to get the setup thats for sure, there is somebody who was supposed to make the drawbar and crossmember but i have not been able to get contact, wonder if your truck had the belt pulley from factory, might still be around the farm it came off of, lucky as you are i sure would ask around for it, hope it is sitting in saddle room on back shelf! Do you have the carrier support for the rear driveshaft? Have you ever put the aftermarket lift from Saginaw tractor or any other conversion company on a tractor, i am thousands of miles from closest one, thanks for the ford link/pn on ebay, bet clint sells some more orders for his repro support, thanks again!
Follow Ups: