Posted by Unbelted 4 now on Friday, December 20, 2002 at 12:28PM :
In Reply to: Re: Belt Pully on PW make your own from a 8N part posted by Dan in CO(Lucky) on Friday, December 20, 2002 at 11:39AM :
The pulley drive usually bolts up to the tractor or truck by being bolted up to the transmission/finaldrive housing or in the ffpw the crossmember, Willy, please post a picture of ford setup, i will post picture of the d4 pulley i have, i am sure these had to share some similar parts up to the external pillow block housing, bet the bevel gear are all the same, pulley sure looks to be. What does the rear of your truck look like, do you have opening for pillow block in your crossmember or is the shaft you have the front winch set up, 1010 john deer pto shaft bolts up to spline coupling on d4 pulley, just have to make adater to driveshaft yoke. I have never seen Ford unit.
Follow Ups: