Posted by Eric B. on Sunday, December 15, 2002 at 8:51PM :
In Reply to: AXLESHAFTS (W200 REAR) Continued posted by Jason in Utah on Sunday, December 15, 2002 at 6:51PM :
You need rear axle shafts from a Corporate rear axle, most likely interchanges 54-60.
54-56 1 tons 2wd
57-60 1 tons 2wd
57-58 3/4 tons 2wd
57-60 3/4 ton 4wd
Late 58 1/2 ton 4wd
Some P series up to 62 or so.
Gear ratio does not matter, but these axles are a bit hard to find, I know of a couple, and I have a couple more, but I wont pull axle shafts from good axles.
Anyone got what he needs, speak up, I would check weights before quoting him a price, as they are moderately heavy to ship.
There are plenty of yards in your area Jason, and I have found other 58 W100-W200s within a few hours of you, seek and you shall find!
After further thought I think you might be able to use the axle shafts from a 1939-53 1 ton as well. They have different backing plates, and drums, but the axles may be the same.
M-37, FF pw axles do not interchange to my knowledge.
I will comment here, that poor or not, parts have a given value, and I would not sell a good set of these axle shafts for much less then VPW is asking. Why? Because if the axle shafts are good, most likely so is the axle, and why split up one of these axles for less then $300?
Eric
Follow Ups: