Posted by Terry in Bozrah on Thursday, November 21, 2002 at 12:18PM :
In Reply to: Re: WDX rear spring shackle removal posted by Joel on Thursday, November 21, 2002 at 9:25AM :
6" long x 1/4" dia NPT water pipe.
Take one of your grease fittings down to the hardware store so you to match it up for size.
Yes you thread the water pipe into the grease fitting hole.(same thrd)
Then vise grips clamp onto the end of pipe.(not around the dia, but from the end)
Than with the slide hammer is welded to the end of the Adjustment screw on slidehammer.
Than you can band those pins out.
Don't fell bad I did the same thing!!
Once you get all the parts and pieces you'l
say DAH like I did.
Hope this helps
Terry
Follow Ups: