Re: Who turns input shaft down to flatfender spec?


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by Brushbuster on Wednesday, July 10, 2002 at 4:02PM :

In Reply to: Who turns input shaft down to flatfender spec? posted by Waiting on 5 speed guy on Wednesday, July 10, 2002 at 2:43PM :

Try Quatum Machine, 910 Frazee Road, Frazee Minn, 56544, attention scott, phone 218 334 3200, recommended by tom woods driveshaft guy in all 4x4 mags. I sent 2 shafts, 2 bellhousings, t/o bearing and a cutdown transmission case for fitting to these guys, they understand input shafts, heat treating and all the mud bogging stress, you can tell if you have tried like i have, most people think you are on crackpipe in texas machine shops where i am, like hey why dont you just buy a new truck, or like use the transmission that came in it, or like wow i don't know, but somebody does it i guess?



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com