Slip joint clocking ?

[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]

Posted by Chris Case [172.70.211.184] on Sunday, May 28, 2023 at 13:28:02 :

In Reply to: Re: u-joint angles, Thanks John! posted by Vaughn [172.70.206.215] on Sunday, May 28, 2023 at 10:17:41 :

The two parts of the drive shaft have to be clocked paralell, NOT 90 degrees off.

Re angles, on my stock drive line, the t/c bushings needed shimming. 1/4" of 1/2" fender washers in the front gave the proper angle to match the rear pinion, and bringing the front down that 1/4" also brought the intermediate shaft angles to a match. To heck with the front drive shaft, what wiht lockout hubs.

Follow Ups:

Re: Slip joint clocking ? - Greg Coffin 15:31:48 05/28/2023

Re: Slip joint clocking ? - Greg Coffin 15:41:58 05/28/2023
- Re: Slip joint & TC investigations, and carb level - Jason Mills 07:12:51 05/29/2023
  - Re: Slip joint & TC investigations, and carb level - Vaughn 12:31:18 05/29/2023

Post a Followup

Name:
E-Mail:
Subject:
Message:

Optional Link
URL:
Title:
Optional Image Link
URL:

(1) Type your Message (2) Load New Code (3) Type new code into box. (4) Click "Post Message" button