1950 Dodge Power Wagon $2,500 [WA]


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by Power Wagon Classified Ads [172.70.174.101] on Monday, April 24, 2023 at 17:53:55 :


1950 Dodge Power Wagon. Shop built wrecker body. This truck was left sitting in the woods for about 2 decades before I bought it. The wrecker winch is off a WW2 2.5 ton 6x6, and the rear fenders are WW2 bomb truck. The rest is shop built.

Truck still has its original T137 engine, which is stuck. The truck is titled to this engine number, and I have a clear Washington signed off title from the farm co-op that used it for a wrecker and snow plow. I was told that there was originally a framework that ran the wrecker cable over the top of the cab that raised the snow plow. That is all gone now.

At some point the frame buckled behind the cab, and the wrecker framework dented the back of the cab pretty good. They straightened and reinforced the frame, but in my opinion it should be replaced.
Other than the damage to the back of the cab, it is pretty straight and there is very little rust in it.

Truck has 7.50x16 duals on it, but still has the 5.83 gears. The two outer rear tires will not take air, but the others hold air and it rolls fine.
This truck will come with the following extra parts:
Front axle housing
Rear axle housing
2-5.83 pumpkins
Transfer case
Misc brackets and pieces
Radiator

I will never get around to this project and am hoping it will find a new home with somebody else that has the ambition to totally rebuild one. To be clear, this truck does not run, drive, or stop. It does roll.
This truck will need a total and complete rebuild but is very fixable and has a clear title.
I am not interested in any trades. I am looking to sell for cash that I can put into another project.
I can provide other pictures if you need something specific.

George
509-710-7925
[email protected]



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


(1) Type your Message (2) Load New Code (3) Type new code into box. (4) Click "Post Message" button