Re: Clutch again

Posted by Dean in IN [172.70.131.210] on Friday, July 29, 2022 at 08:04:44 :

In Reply to: Re: Clutch again posted by Steve in FH [172.71.142.157] on Friday, July 29, 2022 at 02:03:04 :

Take a steel straight edge and lay across the flywheel to check for surface flatness.
Use a flash light behind the straight edge to see if any light shows between the flywheel and straight edge.
Give you an idea if it needs surfacing.

• Old Stumpy

Follow Ups:

• Re: Clutch again - Steve in FH 11:18:43 07/29/2022
  • Re: Clutch again - Keith in Washington 12:39:17 07/29/2022
    • Re: Clutch again - Steve in FH 17:08:09 07/29/2022
  • Re: Clutch again - Jerry in Idaho 11:35:17 07/29/2022
    • Re: Clutch again - Keith in Washington 12:06:35 07/29/2022
      • Re: Clutch again - Jerry in Idaho 12:37:56 07/29/2022
        • Re: Clutch again - Todd Miller 18:50:25 07/29/2022
          • Re: Clutch again - Jerry in Idaho 19:15:12 07/29/2022
        • Re: Clutch again - Keith in Washington 12:48:12 07/29/2022
          • Re: Clutch again - Clint Dixon 13:07:03 07/29/2022
            • Re: Clutch again - Steve in FH 17:11:41 07/29/2022
            • Re: Clutch again - Tom Petroff (IL) 14:28:21 07/29/2022
            • Re: Clutch again - Jerry in Idaho 13:32:32 07/29/2022
              • Re: 120 degrees... - john eickhof 18:04:42 07/29/2022
                • Re: 120 degrees... - Mike in Pa. 21:29:27 07/29/2022
                  • Re: 120 degrees... - john eickhof 23:18:40 07/29/2022
                    • Re: 120 degrees... - Mike in Pa. 16:21:09 07/30/2022

Post a Followup