Posted by Dave [172.68.133.225] on Tuesday, August 06, 2019 at 09:07:47 :
In Reply to: Re: Would this pitting cause me grumbling noise? posted by Kevin in Ohio [173.245.54.4] on Tuesday, August 06, 2019 at 08:59:46 :
It’s been replaced. Twice actually
It’s adjusted with sufficient free play
I’ve even left off the bottom flywheel pan, and when warmed up , have crawled under truck to visually determine the TO bearing is not rotating
I don’t believe that TO bearing retainer / collar can cause this noise...It’s pretty snug on the front bearing retainer.
I guess if it was a sloppy fit riding on the bearing retainer it could rattle, but that’s not happening either.
Using a thin wooden paint stirrer, I’ve actually pushed up and against the TO bearing and carrier while the truck was idling to prove to myself it wasn’t rattling
Didn’t like sticking my hand anywhere near that spinning clutch though!