1965 W300 Dodge Power Wagon $15,000 [CA]


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by Photo Classifieds [162.158.79.104] on Sunday, September 30, 2018 at 12:27:14 :


1965 1-ton W300 Power Wagon 1 Ton 4X4 P/U, with 9 foot box and PTO winch.
This truck is drivable, but is being sold for restoration or parts.

This was a west coast Forest Service truck and was from the Big Bear Lake Arrowhead area. I purchased this truck at a GSA auction in San Bernardino on Sept. 6, 1973. It has always been registered in California. In the late 70’s it was painted red, the box wood was replaced, interior was redone, engine rebuilt, and new clutch installed. It has the original engine, transmission, transfer box, differentials, and suspension as when it was purchased. Wheels and tires have been upgraded to 35X12.50/R 16.5 including the spare. It has an aftermarket air conditioner installed but it now needs new a/c hoses. I love this truck; for 45 years if it had gas and a charged battery, it would always start and run. It has been a good truck, but now it’s time for a new owner who has the time to restore it again.
Mileage estimate is about 83,000.

Specifications:

Vehicle Model W300
Engine 318 V8, two barrel carburetor, about 25,000 miles on rebuilt engine
Graybar PTO winch with ½” steel cable Model 7L RSH
Transmission 435 4 speed with granny low
Axles are Spicer 70 with 4:88 ratio
Warn hubs
Power brakes with reserve vacuum reservoir and vacuum gauge
Side mounted spare
Military type front axle joints WM300
Second 26 gallon fuel tank installed with electric fuel pump (Note: original tank is in the cab)
Alternator has been upgraded to 1970’s type with electronic regulator
Windshield wiper with three speed motor
Tool storage box on right side
Curb weight 6500 lbs
Max . G. V. W. 10,000 lbs.
Asking $15,000

Call Ed Cell # 661 803-0660 or email [email protected]
Located in Santa Clarita CA



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


(1) Type your Message (2) Load New Code (3) Type new code into box. (4) Click "Post Message" button