Re: Paging Alex J - Horn Wire


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by Alex J [162.158.78.115] on Monday, April 24, 2017 at 12:38:33 :

In Reply to: Paging Alex J - Horn Wire posted by Greg Coffin [172.68.34.103] on Monday, April 24, 2017 at 11:25:39 :

I will have to look for my pictures. My setup is really odd. I gundrilled the steering shaft down a few inches, and then milled a very shallow angle opening for the wire to come out. Yes, it weakens the steering shaft some but with the power steering I am not planning on wrenching the wheel around like the original trucks had done. Then on the side of the shaft, the wire terminates to the spring tang similar to a distributor cap. This rides on an insulated ring that then a wire comes out of the side of the column below the dash. I know it will wear out in enough time but am prepared to fix or repair it then. Its all stuff that I made. Plus, I needed the wire to come out inside of the cab to go to my CanBus Master cell rather than coming out already under the hood. The CanBus will tell the front power cell to honk the horn.



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


Enter the characters in the image to the left or Load New Code