Posted by Chris Case [108.162.215.133] on Friday, January 20, 2017 at 21:45:55 :
In Reply to: Re: Distributor woes solved- picture link posted by hemimech [162.158.75.205] on Friday, January 20, 2017 at 21:39:12 :
But the center section of the shaft is turned smaller than the end where the key is. They turned the shaft smaller for a reason- to clear the weight.
Hmmm, I wonder where the carnk weight clocks the dist? I learned in the tune up shop to always bump the engine to turn the rotor to point straight ahead before removing the dist. The weight goes about half way around, I wonder f he was turned to #1 at 4:00 instead of 700?
Follow Ups: