Posted by Kaegi [108.162.246.44] on Friday, January 20, 2017 at 14:25:46 :
In Reply to: 2 speed TC in 1/2 ton WC posted by Dozerman51 [172.68.132.128] on Friday, January 20, 2017 at 13:21:48 :
it would have to be custom brackets. no 1/2 tons ever came with a 2 speed. being a flat cross member you are only dealing with a 90 degree bracket situation so should be fairly easy to fab some. I would us the geometry of the single speed to figure out exactly where the location of the input shaft needs to end up. In other words, measure down from cross member to center of input yoke on the single speed. then measure distance to frame rails for lateral measurement, then design brackets so 2 speed input is exactly in same place.
Follow Ups: