Posted by mannyc [162.158.62.210] on Monday, January 16, 2017 at 12:18:46 :
In Reply to: Re: rotor hub and posted by clueless [108.162.210.121] on Monday, January 16, 2017 at 12:13:26 :
like i say, if it works and is safe, good. I'm running the helitool setup front and rear which is at least the 2nd generation improvement of tim peterson's design. the machining ray did on the flange was far better than stock and is super safe. id feel better sandwiching the rotor between the wheel and the outer face of the hub. the studs would hold the wheel and rotor in place. drilling 10 holes toward the inside edge of the hub doesn't weaken that area? stay safe.
Follow Ups: