Posted by clueless [108.162.210.121] on Monday, January 16, 2017 at 11:51:25 :
In Reply to: Re: rotor hub and posted by Jay Massy [172.68.133.63] on Monday, January 16, 2017 at 11:33:44 :
can t really do that-- i don t see enuff meat in the wheel flange where the head sits--
the rotor is sucked down on top of the wheel studs on each side of it
the bolt flange on the rotor is 1/2 thick
machinist said i was good to go and he did a great job--the lug studs i used are 1/2 in thread and 14 plus mm spline th. vs the stock rotor bolts that were 12mm thread th.--the 1/2 thread fit in the rotor flange holes
i used my worst hub for the trial run as you can see in this pic how offcenter the wheel stud heads are in their designated area on the hub---------wonder how many hubs came off centered like this
little concerned about the bearing surface of the rotor to the wheel stud head but looks good to me and the machinist said i was good
Follow Ups:
