Rear Pto Spacer

Posted by Milo in Pa [162.158.79.170] on Tuesday, December 20, 2016 at 17:56:55 :

The rear PTO has a ridge that fits a original power wagon belt pulley. So for my tractor pulley I had a spacer made so the contact area would be flat when mounting. I had 2 made you can see one hanging on the trailer hitch the other one is installed on the pto.The shop punched the measurements into his computer and went out in the shop and laid a flat piece of 1/4 inch steel on the table and pushed a button and in a few seconds it was cut out.I had one made for me and one for Stefan in South Carolina. The shop saved the measurements on his computer

• spacer

Follow Ups:

• governor? - wayneh 13:04:05 12/21/2016
  • Governor? - Clint Dixon 19:31:46 12/21/2016
    • http://abl-architecte.fr/images.asp?key=new-balance-996-noir-et- - new balance 996 noir et or 04:28:20 12/24/2016
    • Re: Governor? - Wayne H 22:24:39 12/21/2016
      • http://abl-architecte.fr/images.asp?key=new-balance-u410-marine - new balance u410 marine 05:05:07 12/26/2016
  • Re: governor? - Milo in Pa 17:55:48 12/21/2016
• Re: Rear Pto Spacer - Jerry in Idaho 19:29:43 12/20/2016
  • Re: Rear Pto Spacer - Milo in Pa 22:22:40 12/20/2016
• Re: Rear Pto Spacer - Greg Coffin 19:27:38 12/20/2016
  • Re: Rear Pto Spacer - Milo in Pa 22:16:26 12/20/2016
    • Re: Rear Pto Spacer - Greg Coffin 22:34:06 12/20/2016
      • Re: Rear Pto Spacer - Milo in Pa 11:01:37 12/21/2016

Post a Followup