Posted by clueless [108.162.236.139] on Tuesday, May 24, 2016 at 10:44:50 :
In Reply to: Re: that was my original thinking however posted by Dean in CA [162.158.255.108] on Monday, May 23, 2016 at 15:32:56 :
sweet-----i could also use the stock ffpw tie rod ends with a short tie rod but then i have to make a knuckle arm with a tie rod hole or mod the stock one but not sure there is enuff meat--or i could cut the stock drag link at said length and thread it for a tie rod
or i could use the ball from vpw in the tie rod end hole on sam s pitman arm and use the stock drag link cut in half and threaded for tie rod end sleeve to put it back together rotated so the hole and ball line up
thnx again--sam s pitman arm looks nice and strong--by the same token i like using the stock pitman arm to keep the look
