that was my original thinking however


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by ed [108.162.236.139] on Saturday, May 21, 2016 at 10:38:21 :

In Reply to: one step ahead of posted by ed [108.162.236.139] on Saturday, May 21, 2016 at 10:27:01 :

upon consulting the forum the op i got was that the stock draglink performs as well as tie rod ends and since i want to keep the stock look as much as possible!!?? i decided to use it

and since the early bronco std rot box works for my mod and the wdx stock pitman arm fits the bronco spline but the hole in the drag link does not line up with the stock pitman arm swinging horizontally on the bronco box--i decided to cut the stock drag link in half and thread each pc to put em back together again with a tie rod adjusting sleeve that way i can rotate the hole in the drag link to line up with the pitman arm and have some rooom to adjust it to where the box is mounted on the frame

however if i was to determine that tie rod ends are more better then would use the stock bronco pitman arm and make a knuckle arm reemed for another tie rod end and i would probably use the stock wdx tie rod ends and accorded tie rod as the new draglink but i like the above scenario more better-----but always open to suggestions and thnx for the op



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com