make your own pitman arm

[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]

Posted by ed [108.162.236.193] on Friday, May 20, 2016 at 15:16:53 :

the stock pitman arm i pulled the ball is pretty will worn--might clean up and work?!

i was(am?) gonna use it on the bronco ps box but was gonna have to mod the draglink(cut in half and thread for a sht tie rod) so i can put the holes in line with the balls)

but i could just make or buy one of these and weld in the spline off my not so good stock pitman arm-----by the ball from vpw and ream accordingly it so it lines up with the holed in the drag

link

Follow Ups:

Re: make your own pitman arm - Don Williams 17:29:17 05/20/2016

Re: make your own pitman arm - Bruce in sunny BC 15:27:00 05/20/2016

Re: make your own pitman arm - ed 10:14:27 05/21/2016
- one step ahead of - ed 10:27:01 05/21/2016
  - that was my original thinking however - ed 10:38:21 05/21/2016
    - Re: that was my original thinking however - Dean in CA 23:45:31 05/21/2016
      - Re: that was my original thinking however - ed 10:15:52 05/23/2016
        
        Re: that was my original thinking however - Dean in CA 15:32:56 05/23/2016
        
        Re: that was my original thinking however - clueless 10:44:50 05/24/2016

Post a Followup

Name:
E-Mail:
Subject:
Message:

Optional Link
URL:
Title:
Optional Image Link
URL:

This board is powered by the Mr. Fong Device from Cyberarmy.com