Ignore the curve, welding will warp it worse

[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]

Posted by Chris Case [108.162.215.186] on Wednesday, May 11, 2016 at 19:16:42 :

In Reply to: Sheet metal reapair - lower door corner posted by Galen [173.245.54.66] on Wednesday, May 11, 2016 at 11:09:24 :

Weld it, bend it around the edges, and it's going to need a bit of bondo regardless. Even if it's a bona fide patch panel.

Yes, the door has a curve, but lay a straight edge on it and see how much it curves over the 4". Plus, the door skin will also warp by the time you are done.

If you weren't witing for patch panels, you'd be done by now. :^)

Follow Ups:

Re: Ignore the curve, welding will warp it worse - Galen 09:04:45 05/12/2016

Re: Ignore the curve, welding will warp it worse - Kevin in Ohio 11:46:05 05/12/2016
- Re: Ignore the curve, welding will warp it worse - Galen 13:27:28 05/12/2016

Post a Followup

Name:
E-Mail:
Subject:
Message:

Optional Link
URL:
Title:
Optional Image Link
URL:

This board is powered by the Mr. Fong Device from Cyberarmy.com