Posted by Milo in Pa [173.245.54.20] on Sunday, January 17, 2016 at 20:20:38 :
In Reply to: Re: It's Gone? posted by CSCameron [108.162.215.127] on Sunday, January 17, 2016 at 19:51:19 :
Also when I did mine I looked a the picture of Chris truck and bent the frame I marked the frame with chalk and used a 14 inch pipe wrench with a pipe attached for leverage and worked along the area needing bent it was easier than I thought it would be. You can see in the picture where I cut some off one of the ears on the unit close to the frame. I also ground a couple spots on the bracket and added a couple washers under one side of the unit for a better fit
Follow Ups: