Posted by Photo Classifieds [173.245.56.142] on Monday, December 28, 2015 at 18:00:42 :
Complete Braden LU2 PTO winch set up.
This came off of a 1963 Dodge W200 Power Wagon, this is a complete set up, and will bolt up to any Dodge truck of this era. If you have a Dodge truck similar to this, then it is a direct bolt in.
I am including the NP201 transfer case, factory mounting ears to bolt up the transfer case to the frame (they are a little beat up, I had to grind some welds off from the previous owner). The factory frames already have the holes drilled into the frame for all these provisions. I am also including the factory bracket that bolts to the frame to mount the twin stick shift handles, the shifters and linkage are in good condition, also included are the mini drive shafts from the PTO all the way to the actual winch, including the two factory intermediate mounting brackets, the stock brackets that bolt to the frame and attach to the winch have been cut at some point but are structurally sound and are just angle so it is easy to reproduce. The bracket that engages the PTO sits under the driver on the left side adjacent to the transmission hump. This is a 100% complete bolt in package, you will find every hole is already drilled and ready to accept this bolt in package. I pulled this from a complete truck that has been sitting for about 10 years. I was told everything was in operational order before it was parked due to a death in the family.
I can load on a pallet, and drop off at a shipper for an additional $100, or feel free to come by and pick it up In Albuquerque NM.
This is a really cool unit that will set you off from the average Power Wagon out there, or if you have a 2 wheel drive this is a great start to convert to 4WD. The passenger side aluminum cover has been repaired.
Contact Jason [email protected]