Posted by Clint Dixon on Sunday, September 09, 2001 at 12:17PM :
In Reply to: Signal Stat arrow turn signals posted by Kevin in Ohio on Saturday, September 08, 2001 at 6:15PM :
Kevin,
I got exited about mine too when I found them. They look great on a Power-wagon. Congratulations! I have to agree with Fred on the mounting positions. I do not have headlight guards, but I removed the trim pieces from the sides of the grill and mounted mine directly to the upper holes in the grill sides. Not completely protected, but more so than on the fenders. What mainly kept me from mounting them on the fenders was that the wire would be exposed to road grime, rocks, and tire chains. The rears I mounted to triangle shaped brackets cut from 1/8" thick sheet steel. I drilled a hole in each point of the triangle. One to mount the turn signal to and two to mount to existing holes on the underside of the rear C-channnel of the pickup bed. This puts them up close to the underside of the bed and next to the frame rails. They hang upside down like bats as Fred mentioned. Well protected from everything but rock chips. No holes were drilled in mounting any of these turn signals so everything can be returned to original if needed.
Clint
|
This board is powered by the Mr. Fong Device from Cyberarmy.com |