Posted by Willy-N [72.168.160.99] on Saturday, December 05, 2015 at 21:02:40 :
In Reply to: lower it so the radius of the booster sit inside the posted by clueless [201.202.24.222] on Saturday, December 05, 2015 at 14:45:55 :
I can keep the rod strait using the lever and lowering the unit down some now that I flipped the bracket. That will put the 4 holes in it level with the top of the frame for the bracket going strait across to bolt on the top of the frame. Nice thing is the pivot point is above the plunger rod about the same as the lever is down from the center of the plunger. That makes it about the same amount of travel as the lever does going back. So they should be real close to moving the same amount. When I get time I will measure the original rod to figure how low it needs to go. Then make my mount for the Hydro Vac and have a starting point to work off of. It is snowing out pretty good so I get to plow snow tomorrow instead of playing with the PW for a while! Not 70 degs outside like where you live, were having winter weather now.
Follow Ups: