WC1/2 pitman arm spline ID - same as WDX?

[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]

Posted by Don in NH [69.131.112.246] on Friday, November 20, 2015 at 16:14:46 :

Hi all,

I got my PS box - 27-7515, which is listed as having the same output shaft as the the 27-7500 which is a replacement for the PS box found on the 74-78 Dodge PWs. The diameter is listed as 1.25 where the taper starts at 1.185. My pitman arm does not fit on this, the ID of the pitman arm too small.

Does anyone know if the ID of the pitman arms is different? Do I need a WDX pitman for the PS conversion? Or I am screwing up my cross-referencing of various part numbers?

Thanks.

Follow Ups:

Re: WC1/2 pitman arm spline ID - same as WDX? - Milo in Pa 11:30:25 11/21/2015

Re: WC1/2 pitman arm spline ID - same as WDX? - Tom @ Snake River 23:23:18 11/20/2015

Allowing for the double spline? - Chris Case 17:18:46 11/20/2015

being lazy I elected to - muddy coast Bruce 18:58:41 11/20/2015
- Exactly. - Chris Case 19:05:11 11/20/2015
  - Re: Unfortunately it doesn't even start - Don in NH 19:28:40 11/20/2015

Re: WC1/2 pitman arm spline ID - same as WDX? - Tim Holloway 16:59:30 11/20/2015

Re: Then I don't get it! - Don in NH 19:26:00 11/20/2015

Re: WC1/2 pitman arm spline ID - Don in NH 16:45:47 11/20/2015

Re: WC1/2 pitman arm spline ID - Mike O in CO 21:54:18 11/20/2015
- Re: WC1/2 pitman arm spline ID - Don in NH 22:40:29 11/20/2015

Post a Followup

Name:
E-Mail:
Subject:
Message:

Optional Link
URL:
Title:
Optional Image Link
URL:

This board is powered by the Mr. Fong Device from Cyberarmy.com