Different releive valve design? Or a constriction in a fitting?

Posted by Chris Case [108.247.147.90] on Sunday, November 15, 2015 at 18:52:48 :

In Reply to: thnx--makes sense--however my 230 posted by ed [186.15.45.20] on Sunday, November 15, 2015 at 17:10:39 :

In my brass drawer I have a fitting that is 1/8 pipe OD, but only has a 1/16" hole inside. Not sure is it was from a filter or in the gauge line.

• http://photos.imageevent.com/bigchriscase/exhaustheadersandintakemanifold

Follow Ups:

• Re: Different releive valve design? Or a constriction in a fitti - clueless 23:01:12 11/15/2015
• Re: Different releive valve design? Or a constriction in a fitti - Daryl in Oz 22:16:11 11/15/2015
  • thnx again daryl now i know where to put it--so - clueless 23:02:49 11/15/2015
    • Re: thnx again daryl now i know where to put it--so - Daryl in Oz 01:57:04 11/16/2015
      • Re: thnx again daryl now i know where to put it--so - clueless 10:23:29 11/16/2015

Post a Followup