Posted by Willy-N [72.171.192.117] on Thursday, November 05, 2015 at 22:13:23 :
In Reply to: Installing Door Glass Assembley Order? posted by Willy-N [72.171.192.117] on Thursday, November 05, 2015 at 20:09:18 :
Hi Joel! Here's how I got mine in last week.
1. Insert window glass run, but don't screw in yet. This is the piece that goes up the rear channel and around window opening, ending at top of vent wing. It's either chrome edged or plain. When securing to rear channel, you use the tab at bottom of channel.
2. Install vent wing window.
3. Install front channel, but don't tighten the screws. It needs to move a bit at the top to let the full window fit in. I broke my new glass the first attempt by not allowing enough room.
4. Install the window regulator. Crank regulator almost all the way down.
5. Open vent wing and insert window carefully.
6. Lower window until the two forward openings in its channel mate up with the two wheels on the regulator. You will need to lower or raise the regulator until the regulator wheels match the channel gaps correctly.
7. Lube channel and insert wheels.
8. Crank window up a bit untill rollers move beyond openings in channel.
9. Install stop screw.
10. Tighten screws in front channel and install screws in door glass run.
Follow Ups: