Re: dead parallel ,,, .5 of a degree off is even better.

Posted by Willy-N [72.171.192.61] on Thursday, September 10, 2015 at 14:55:46 :

In Reply to: dead parallel ,,, .5 of a degree off is even better. posted by Bruce in BC [24.207.106.243] on Thursday, September 10, 2015 at 14:26:53 :

Just found this diagram and did some reading and they like a 3 deg max angle but both input and output should be parallel to each other no matter what the angle. If the driveshaft is strait that is bad also cause the needle bearing won't turn and lubricate the universal joint properly.

• Bed Frame Build

Follow Ups:

• That is the ticket - Bruce in BC 16:27:59 09/10/2015
• It could even be worse than that - Sherman in Idaho 15:57:21 09/10/2015

Post a Followup