Re: Jack Shaft Angle Degrees?

Posted by Willy-N [72.171.192.61] on Thursday, September 10, 2015 at 13:40:55 :

In Reply to: Re: Jack Shaft Angle Degrees? posted by Sherman in Idaho [72.47.153.163] on Thursday, September 10, 2015 at 13:32:57 :

They appear to be strait and level on both but the transfer case is lower. Everything is stock PW at this point on the frame. I did not notice any shake or noise when I drove it and there was only a little 3/4" section of wood blocking it from view.

• Bed Frame Build

Follow Ups:

• dead parallel ,,, .5 of a degree off is even better. - Bruce in BC 14:26:53 09/10/2015
  • Re: dead parallel ,,, .5 of a degree off is even better. - clueless 17:34:40 09/10/2015
  • Re: dead parallel ,,, .5 of a degree off is even better. - Willy-N 14:55:46 09/10/2015
    • That is the ticket - Bruce in BC 16:27:59 09/10/2015
    • It could even be worse than that - Sherman in Idaho 15:57:21 09/10/2015

Post a Followup