Posted by Willy-N [72.171.192.120] on Monday, August 10, 2015 at 23:45:30 :
Finished the last one today so both are ready for paint. No surprises welded up OK and getting better at it. Found if you can't get to the back of the hole you can slide a sliver of sheet metal into the hole holding it flush. Then you tack weld it in and at the same time pull back on it when it puddles to finish the weld. The strip will separate and leave a small section to stop blow thru. I also did the insides parts for both. Tomorrow the cab may be ready so soon I get to spray! Time to figure out all the window trim I need for the doors.
Follow Ups: