Notch or hole in crossmember of WC?


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by Chris Case [108.225.237.77] on Thursday, July 30, 2015 at 17:42:59 :

In Reply to: Re: Hydraulifying an MU2 on a WC1/2ton posted by Don in NH [216.107.193.154] on Thursday, July 30, 2015 at 15:56:34 :

I did put a winch on my WC Command Car, but it was an MU-5 what I shoehorned inside of the frame channels. I too had to change tranny cases to get a left side PTO. My driveshaft was a re-purposed hollow tube from a car. Under a load that dragged the front end down the shaft would rub on the axle housing. So I bought one spring pack, shuffled the tree into two, adding both lift and capacity.



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com