Re: nice----looks like it is sitting level instead of


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by Willy-N [72.171.192.121] on Friday, July 10, 2015 at 11:51:37 :

In Reply to: nice----looks like it is sitting level instead of posted by ed [201.202.24.222] on Friday, July 10, 2015 at 10:55:36 :

I made 2 plates to start with. The top one was made and drilled to fit the original holes. Then I made one for the Mater Cylinder. Bolted the top plate on and took the second plate and lined it up for the proper angle and ground off anything in the way. Tacked it put it back together again then removed and welded up the gussets. When the plate was tacked I pulled the master cylinder down into place level then welded it solid. Since I lowered the master cylinder to fit I had to bend a "Dog Leg" in the rod so it went strait into the cylinder again. I checked it would go thru the hole stroke strait after a few adjustments. The whole process took most of a day to do since I had to install and removed it several times to get the bracket to fit right.



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com