Back to Working on the Brakes

Posted by Willy-N [72.171.192.60] on Thursday, July 09, 2015 at 12:04:23 :

I removed my master cylinder yesterday to make room for the new one. I got the bracket made for the original mounting holes. I think I am going to use another plate drilled out for the new master cylinder and attach the two together. That way I can still use 5 bolts to hold it on and set the angle with the 2nd plate. Then I will weld the two together with the 3 Grade 8 bolts loose enough to turn between them. I don't want to drop it down this time to fit. I want the original bracket the same and make this to just bolt on no modifications to the stock bracket. Anyone else make a bracket for these Ford Truck Master Cylinders and got a picture of it?? I will post some later today if all goes well. Get my part at Noon today.

• Reverse Shackle Artical

Follow Ups:

• Re: New Master Cylinder Installed Now Pict. - Willy-N 22:09:34 07/09/2015
  • Re: New Master Cylinder Installed Now Pict. - clueless 16:05:04 07/10/2015
    • Re: New Master Cylinder Installed Now Pict. - Willy-N 19:17:51 07/10/2015
  • nice----looks like it is sitting level instead of - ed 10:55:36 07/10/2015
    • Re: nice----looks like it is sitting level instead of - Willy-N 11:51:37 07/10/2015
  • Re: Under Fender View Picture - Willy-N 22:13:05 07/09/2015
    • Re: Different Angle View - Willy-N 22:17:50 07/09/2015
      • Re: Fixed Over Load Pad - Willy-N 00:03:28 07/10/2015
        • Re: Fixed Over Load Pad - Daryl in Oz 09:00:15 07/10/2015
          • Re: Fixed Over Load Pad - Willy-N 11:42:27 07/10/2015
            • Re: Fixed Over Load Pad - w200Tim 20:35:34 07/10/2015
              • Re: Fixed Over Load Pad - Willy-N 21:10:15 07/10/2015
• Re: Back to Working on the Brakes - clueless 13:07:35 07/09/2015
  • Re: Back to Working on the Brakes - clueless 13:36:24 07/09/2015

Post a Followup