Re: Daryl can you explain


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by Daryl in Oz [211.27.83.133] on Monday, June 01, 2015 at 18:43:52 :

In Reply to: Re: Daryl can you explain posted by Willy-N [72.171.192.120] on Monday, June 01, 2015 at 15:53:41 :

That's right Mark, tightening the last bit is what usually causes them to bend up. When you get right into it, the front and rear brackets only need to be a little out of square to make a difference. If you loosen the bolts front and rear one end at a time, see how much it springs out. The rear bracket only needs a little bit to make a difference, where the front one can be pulled forwards to make a difference. Mine being made from all sorts of bits was bad both sides, one a lot worse so had to slot the rear mount on one side a bit to get the last bit.



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com