Posted by Terry in Lyme [76.127.191.217] on Tuesday, May 05, 2015 at 20:48:08 :
In Reply to: Re: Rear Spring Removal posted by john [66.102.8.241] on Tuesday, May 05, 2015 at 20:06:09 :
6" long x 1/4" dia NPT water pipe.
Take one of your grease fittings down to the hardware store so you to match it up for size.
Yes you thread the water pipe into the grease fitting hole.(same thrd)
Then vise grips clamp onto the end of pipe.(not around the dia, but from the end)
Than with the slide hammer is welded to the end of the Adjustment screw on slidehammer.
Than you can band those pins out.
Don't fell bad I did the same thing!!
Once you get all the parts and pieces you'l
say DAH like I did.
Hope this helps
Terry